Configuring a PnPVPN Client

This section describes how to configure a PnPVPN Client.

To configure a PnPVPN, take the following steps:

1. On the Navigation pane, click Configure > Network > IPSec VPN to visit the IPSec VPN page.
2. On the Task tab in the right auxiliary pane, click PnPVPN Client.
3. In the PnPVPN Configuration dialog, finish the options.
   • Server address: Type the IP address of PnPVPN Server into the box.
   • ID: Specifies the IKE ID assigned to the client by the server.
   • Password: Specifies the password assigned to the client by the server.
   • Confirm password: Enter the password again to make confirmation.
   • Auto save: Select Enable to auto save the DHCP and WINS information released by PnPVPN Server.
   • Outgoing IF: Specifies the interface connecting to the Internet.
   • Incoming IF: Specifies the interface on PnPVPN Server accessed by Intranet PC or application servers. Click the interface you want. If Incoming IF is selected, also select an interface from the Interface drop-down list; if multiple Intranet interfaces connect to PnPVPN, you should click BGroup IF, and add interface members of that bgroup. To add interface members, select the interface(s) you want from the Available list, and click to add to the Selected list. To delete an interface member, select it from the Selected list and click .
4. Click OK to save the settings.