System > Network > Routing > Source Interface Route
Configure a source interface route to forward the packets based on the source IP and ingress interface of the packets.
In the Source Interface Route page, you can perform the following actions:
Options in the Source Interface Route Configuration dialog:
| Option | Description |
|
Ingress Interface |
Select an interface for the route from the drop-down list. |
|
Source IP |
Type the source IP for the route into the textbox. |
|
Subnet Mask |
Type the corresponding subnet mask into the textbox. |
|
Next-hop |
To specify the type of next hop, click Gateway or Interface. If Gateway is selected, type the IP address into the Gateway textbox; if Interface is selected, select an interface from the Interface drop-down list below. |
| Precedence |
Type the route precedence into the textbox. The smaller the parameter is, the higher the precedence is. If multiple routes are available, the route with higher precedence will be prioritized. The value range is 1 to 255. The default value is 1. When the value is set to 255, the route is invalid. |
|
Weight |
Type the weight for the route into the textbox. This parameter is used to determine the weight of traffic forwarding in load balance. The value range is 1 to 255. The default value is 1. |